1OPERATINGINSTRUCTIONSX-08TM/CEX-08TMType 1FHIGH SECURITY ELECTRONIC LOCKPlease read all instructions carefully before putting your X-08/CEX-08 into o
10The display will flash the new combination two times and then display the symbolPO (Pull Out Change Key).Note: If the correct combination is not di
11USING THE X-08/CEX-08If you have not read the section on “Dialing the X-08”, it is important that you doso before proceeding.SINGLE COMBINATION MODE
12SUPERVISORY/SUBORDINATE MODEIn this mode, two combinations must be correctly dialed toopen the lock. However, it is different from Dual Mode be-caus
13To Lock Up (LU)Supervisory Operator:1. Dial left until lock is”powered”.2. Dial right to dial the Supervisory Combination as if dialing the combinat
14AUDIT FEATURES OF THE LOCKThe X-08 lock tracks the number of successful openings for the lifetime of the lock. It alsotracks the number of consecuti
15SURREPTITIOUS ATTEMPTSA indicates that a Surreptitious Entry Attempt condition exists. An X-08 lock willregister a Surreptitious Entry Attempt cond
16CHANGE RESET COMBINATIONThis procedure is similar to changing a combination when operating in Single Mode.Note: The Factory default for the Reset Co
17Once the lock has been successfully opened, the Reset Combination can be changedusing the serial number.To Change Reset Combination using Serial Num
18CEX-08 FEATURESThe CEX-08 lock is a variation of the X-08 lock that includes a Covert Entry detectionfeature. The Covert Entry function is used to i
19RESET CE CONDITIONIf CE is displayed, then you will need to reset the Covert Entry condition using thefollowing steps. The lock must be powered down
2Table of ContentsINTRODUCTION ... 3LOCK ON BACK COVER ...
20GUIDE TO SYMBOLSBlank DisplayMeans the lock has been reset or is powered down.OPOpen RightLightning BoltIncorrect Combination Dialed. (When this sym
21CCConfirm Combination or Combination(s)CE (CEX-08 only)A Covert Entry condition existsCA (CEX-08 only)Covert entry detection is ActivedLdial LeftE
22www.mas-hamilton.com805-D Newtown Circle, Lexington, KY 40511Phone (888) 950-4715 or (606) 253-4744 FAX (606) 281-5766Technical Support: (800) 950-
3INTRODUCTIONThe X-08/CEX-08 uses sophisticated computer security and makes dialing much easierthan that of traditional combination locks. The micropr
4DIALING THE X-08/CEX-08DIALING METHODSThe user should dial with complete full wrist turns. Stopping to regrip produces pauses indialing activity. Thi
5Note: When dialing to the right after the E1, E2, or E3 prompts, the firstnumbers to appear on the LCD will alternately be 00 or 50. DO NOT stop ont
6OPENING THE X-08/CEX-08 (FACTORY COMBINATION)If you have not read the section on “Dialing the X-08”, it is important thatyou do so before proceeding.
7X-08/CEX-08 LOCK SETUPSetting up the X-08 lock for operation involves both the operating mode and thecombination(s).Before you can set a new combinat
8Note: Hold your thumb on the change key retractorwhile inserting the Change Key to ensure that the pins enterthe lock and are not being pushed back
9The new combination will be displayed twice, two digits at a time, followed by PO.Note: If the correct combination is not displayed, you may pull ou
Kommentare zu diesen Handbüchern